MONTAGUE 243W36 Dokumentacja Pobierz pdf (Strona 9)

SM-9

GAS FIRED BROILERS

9. Reassemble by reversing procedure.

WARNING

ALL GAS JOINTS DISTURBED DURING

SERVICING MUST BE CHECKED FOR LEAKS.

CHECK WITH A SOAP AND WATER SOLUTION

(BUBBLES). DO NOT USE AN OPEN FLAME.

Figure 9. Orifice Assembly

Burner Valve

The burner valves are located on the manifold behind

the control panel cover.

CAUTION

Turn off the gas supply at the manual shutoff

valve that is next to the broiler before

attempting to loosen any gas connections.

1. Remove the control panel cover as described

under COVERS AND PANELS to access the

burner valve.

2. Disconnect the gas line from the back of the

burner valve.

3. Unscrew the burner valve from the manifold.

4. Install the new burner valve.

NOTE: Make sure that the pipe joint compound or

pipe thread sealant that is being used is resistant

to the corrosive actions of liquefied petroleum gases.

5. Connect the gas line to the back of the valve.

6. Turn the main gas shutoff valve to the broiler to the

ON position.

WARNING

ALL GAS JOINTS DISTURBED DURING

SERVICING MUST BE CHECKED FOR LEAKS.

CHECK WITH A SOAP AND WATER SOLUTION

(BUBBLES). DO NOT USE AN OPEN FLAME.

7. Light pilot.

8. Reinstall the control panel cover and control

valve knobs.

9. Turn burner valve full on and check that burner is

properly lit.

Figure 10. Burner Valve

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Brak uwag

MONTAGUE 243W36 Dokumentacja Strona 9