MONTAGUE 243W36 Dokumentacja Pobierz pdf (Strona 7)

SM-7

GAS FIRED BROILERS

DRIP TRAY AND HORIZONTAL

GREASE CONTAINER.

The drip tray is located below the drip deflector.

Grease dripping onto the drip deflector runs off the

back edge to the drip tray then flows forward into the

horizontal grease container.

1. Pull the drip tray straight out the front of the

broiler.

2. Lift the horizontal grease container up and away

from the broiler.

NOTE: When dumping the contents of the

horizontal grease container, be sure to follow

appropriate regulations for disposing of grease.

Figure 4. Drip Tray and Grease Container

PILOT

Adjustment Valve

The pilot adjustment valves are located on the manifold

behind the control panel cover.

CAUTION

Turn off the gas supply at the manual shutoff

valve that is next to the broiler before

attempting to loosen any gas connections.

1. Remove the control panel cover as described

under COVERS AND PANELS to access the

pilot valve.

2. Disconnect the gas line from the back of the valve.

3. Unscrew the pilot valve from the manifold.

4. Install the new pilot valve with the adjustment

screw facing the front of the broiler.

NOTE: Make sure that the pipe joint compound or

pipe thread sealant that is being used is resistant

to the corrosive actions of liquefied petroleum gases.

5. Connect the gas line to the back of the valve.

6. Turn the main gas shutoff valve to broiler to the

ON position.

WARNING

ALL GAS JOINTS DISTURBED DURING

SERVICING MUST BE CHECKED FOR LEAKS.

CHECK WITH A SOAP AND WATER SOLUTION

(BUBBLES). DO NOT USE AN OPEN FLAME.

7. Light pilot and adjust pilot valve.

Reinstall control panel cover and control valve knobs.

Figure 5. Pilot Valve

Pilot Assembly and Orifice

The pilot assembly is located adjacent to each burner.

The connection for the pilot assembly is accessed by

removing the venturi cover.

CAUTION

Turn off the gas supply at the manual shutoff

valve that is next to the broiler before

attempting to loosen any gas connections.

1. Remove the venturi cover as described in COVERS

AND PANELS.

2. Disconnect gas line from back of pilot assembly.

3. Unscrew the two screws attaching the pilot

assembly and pilot assembly bracket.

NOTE: Check condition of the pilot orifice and

replace if damaged.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

MONTAGUE 243W36 Dokumentacja Strona 7

Komentarze do niniejszej Instrukcji